Walgreens Fast Heat Heating Pad 12" x 24" Beige

Feel the heat in 30 seconds 4 heating settings for customizable therapy Machine washable -- soft microplush fabric 2 hour shut-off Clinically proven to provide relief Moist heat option -- machine washable when detached from power cord OPERATING INSTRUCTIONS POWERING ON FOR DRY HEAT THERAPY 1) Plug the power cord into the electrical outlet. 2) Set controller to the desire setting. ON/LOW - Press button once to turn the unit on. LED 1 will light up to indicate WARM heat setting. - Press the button twice and LED 1 and LED 2 will light up to indicate the LOW heat setting. - Press the button three times and LED 1, LED 2, and LED 3 will light up to indicate the MEDIUM heat setting. - Press the button four times and LED 1, LED 2, LED 3, and LED 4 will light up to indicate the HIGH heat setting. 3) Place heating pad on the desired area of the body. AUTOMATIC SHUT-OFF Your heating pad is equipped with a special safety feature designed to shut the heating pad off after 120 minutes of use. When the automatic shut-off feature turns the pad off, the LEDs on the controller turn off. To restart the pad, press the (On/Off) button for the heat selection process to start again. WASHING INSTRUCTIONS DO NOT IRON YOUR HEATING PAD! DO NOT USE BLEACH! DO NOT DRY CLEAN! 1) Unplug the pad from the electrical outlet. 2) Disengage the power cord from the pad by pressing the button and pulling to release power cord. Do not pull by the cord. 3) Machine-wash pad in warm water on gentle cycle; tumble dry the pad on medium heat. Remove the pad promptly from dryer. Alternatively, hand wash in warm water and line dry. 4) DO NOT plug in the pad until it is completely dry. SAFETY MODE SAFETY MODE (TOP LED BLINKING) NOTE: IF THE LIGHT ON YOUR UNIT CONTROLLER IS BLINKING, IT INDICATES YOUR PRODUCT HAS ENTERED INTO SAFETY MODE. THIS DEVICE IS DESIGNED KEEPING YOUR SAFETY IN MIND. IF YOUR UNIT HAS ENTERED SAFETY MODE, PLEASE TRY THE FOLLOWING RESET PROCEDURE: 1) Unplug the pad from the electrical outlet. 2) Disengage the power cord from the pad by pressing button and pulling to release power cord. Do not pull by the cord. 3) Re-plug the power cord back into the pad. Ensure the pad and the controller are fully engaged. 4) Plug the pad into a electrical outlet that is different from one that has been used previously. 5) Set the controller to the desired setting.

Availability verified during our latest store check. If the item isn't on the shelf when our courier arrives, the order is cancelled and you are refunded in full.